A fiber laser focuses a beam produced in a doped optical fibre onto the sheet through a cutting head. It cuts mild steel, stainless steel, aluminium, brass and copper with a very narrow kerf, sharp corners and little heat input – and needs almost no warm-up or alignment.
Choosing the laser power
Higher power means faster cutting and thicker plate, but also a higher price and higher electricity demand.
| Laser power | Typical work |
|---|---|
| 1–3 kW | Sheet metal up to about 6–10 mm, signage, enclosures |
| 6–12 kW | General fabrication up to 20–25 mm, fast cutting of thin sheet |
| 20 kW and above | Heavy plate, high-volume production |
The right size depends on your thickest regular material and the volume of thin sheet you cut. Many fabricators find that a mid-power machine running two shifts beats a very high-power machine that waits for work.
Machine types
- Open single-table machines – the most economical entry into laser cutting.
- Enclosed exchange-table machines (for example the Honeybee HN-H6025) – a closed cabin for safety and fume control, and a second table that is loaded while the first is cutting.
- Gantry lasers for large and heavy plate.
- Plate + pipe machines (Honeybee HNX series) and dedicated pipe and H-beam lasers that cut holes, copes and bevels in tube and profiles.
- Handheld laser welders that also clean and cut – a fast, low-distortion alternative to TIG on thin material.
Assist gas and running costs
Oxygen is used for thick mild steel; nitrogen gives oxide-free edges on stainless and aluminium; compressed air is a low-cost option on thin material. Budget for gas, electricity, protective windows, nozzles and ceramic rings, chiller maintenance and dust extraction. GWS stocks the common laser spare parts and protective windows.
Software
Nesting and control software – CypCut for the machine and FastCAM/StarCAM for nesting – decides material yield. Good nesting typically saves more material than any other single change.
Installation checklist
- Stable floor and a stable three-phase supply (with voltage stabiliser where needed).
- Air-conditioned electrical cabinet and a correctly sized chiller – UAE summers are hard on electronics.
- Gas supply and dry, oil-free compressed air.
- Operator training on the cutting head, nesting and safety.