A magnetic drilling machine ("mag drill") clamps itself to steel with an electromagnet, so you can drill accurate holes in beams, plates and columns exactly where they are – on the floor, on a wall or overhead.
Annular cutters vs twist drills
An annular cutter (core drill) cuts only a ring at the edge of the hole and leaves a solid slug. Because it removes far less metal than a twist drill, it:
- drills holes up to three times faster than a twist drill,
- needs no pilot hole or step drilling,
- leaves a burr-free, accurate hole,
- needs less power – so the machine can be smaller and lighter.
| Cutter | Material | Best for |
|---|---|---|
| HSS | High-speed steel, resharpenable | Mild steel, general structural work, Ø 12–65 mm |
| TCT | Tungsten-carbide tipped | Hard and high-strength steel, rail steel, hard spots, Ø 12–200 mm |
Cut depths are typically 25, 35, 50, 75 or 100 mm. All Promotech cutters have a Weldon shank for secure clamping.
Choosing the mag drill
- Largest hole – a PRO-36 handles cutters up to 36 mm; PRO-55, PRO-62, PRO-72 and PRO-102 go progressively larger.
- Site or workshop – compact and battery machines (PRO-36, PRO-36 Battery) are easiest to carry and use at height.
- Space – low-profile models (PRO-36 AD, PRO-40 AD) drill between flanges and in tight spots.
- Tapping – machines with reverse rotation and variable speed (PRO-52T, PRO-72T, PRO-122T, PRO-152T) drill and tap threads in one set-up.
- Material – on thin plate choose a machine with magnetic field control; on stainless or aluminium use a vacuum pad.
Tapping threads
After drilling the core hole, switch to the tapping chuck and a machine tap. Use spiral-point taps for through holes and spiral-flute taps for blind holes, and plenty of cutting oil. Check the tap-drill size for the thread (for example 10.2 mm for M12 coarse).
Make cutters last longer
- Always use cutting fluid (for example HD-CUT) – heat is the main enemy of the cutting edge.
- Clean the surface and the magnet base; a rocking machine breaks teeth.
- Use the correct speed for the cutter diameter and material.
- Do not force the feed when breaking through – ease off.
- Resharpen HSS cutters on an SM-101 regrinding machine.
Weld preparation and milling
The same Promotech family includes bevelling machines for plate and pipe and the BM-30 WM weld milling machine that mills excess weld flush instead of grinding.