Inverter welding machines and plasma cutters are electronic power supplies. In the UAE they work in high temperatures and fine dust – the two main reasons for breakdowns we see in our workshop. A few habits prevent most of them.
Weekly
- Keep the air inlets and outlets free; never block the fan side against a wall.
- Check cables, plugs and earth clamps for heat damage and loose connections – a bad earth causes unstable arcs and overheating.
- On plasma, drain the air filter and check the air is dry and oil-free; wet air destroys consumables quickly.
Monthly (or more often on dusty sites)
- Disconnect the power and blow out the dust with dry, low-pressure air – or let our technicians do it.
- Check torch liners, contact tips and gas hoses; worn parts make the machine work harder.
- For water-cooled torches, check the coolant level and use the coolant the manufacturer recommends.
Use
- Respect the duty cycle, especially in summer – let the fan run after welding instead of switching off at once.
- Use a generator of the right size with stable voltage; undersized generators cause most electronic failures on site.
- Store machines dry and covered when not in use.
When to call service
Error codes that keep coming back, a smell of burning, tripping breakers or an arc that will not stay stable are signs for a check. GWS repairs inverters, plasma systems and CNC tables in our workshop or on site, and offers maintenance contracts with planned visits.