Plasma cutting is the fastest way to cut electrically conductive metals from thin sheet up to around 50 mm. It cuts mild steel, stainless steel and aluminium without preheating and with a narrow heat-affected zone.
How plasma cutting works
A plasma cutter passes compressed air (or another gas) through a small nozzle and strikes an electric arc through it. The gas is heated until it becomes plasma – hot and electrically conductive – and the jet melts the metal and blows it out of the kerf. The torch consumables (electrode, nozzle, swirl ring and shield) shape the arc and decide much of the cut quality.
Choosing the amperage
| Power source | Typical quality cut | Typical use |
|---|---|---|
| 40–60 A | up to about 12 mm | Sheet metal, maintenance, HVAC |
| 100 A | up to about 25 mm | General fabrication, workshop cutting |
| 160–200 A | up to about 40 mm | Heavy fabrication, CNC tables |
| 300 A and up | thick plate at production speed | CNC production cutting |
Exact figures depend on the machine, gas and consumables – always check the manufacturer's cut chart. The APS Rhino Cut range covers 100 A to 300 A air plasma, while Hypertherm Powermax systems and Kjellberg HiFocus high-definition plasma serve mechanised and precision cutting.
Hand cutting or CNC?
Hand cutting is flexible and cheap to start with. Once you cut the same parts repeatedly, a CNC machine pays back quickly:
- Portable CNC cutters such as the Honeybee Minbee carry the torch on a light gantry that you set up on the plate – ideal for site work and small workshops.
- Table-type CNC plasma combines the gantry with a water or down-draft table and fume extraction for clean workshop cutting.
- Gantry machines with automatic torch-height control and nesting software (FastCAM, StarCAM) cut large plates with minimal waste.
Cut quality and consumables
Bevel, dross and edge squareness come down to amperage, speed, stand-off and consumable wear. Replace electrode and nozzle as a pair, keep the air dry and oil-free, and follow the cut chart. GWS stocks genuine and compatible plasma consumables for the common torches in the UAE.
Plasma, oxy-fuel or laser?
- Plasma is fastest on thin to medium plate and cuts stainless and aluminium.
- Oxy-fuel is still the most economical way to cut very thick mild steel (see our oxy-fuel article).
- Fiber laser gives the best precision on sheet and medium plate (see fiber laser cutting).